Moweb adjusfjiemt, Sipe to side hojustmeilt, Frqwt to bear adjiustmlwt – Sears 917.25591 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURi 17
MOWEB ADJUSfJiEMT
Adjust the mower white tractor is parked on level ground or
tjrlveway. Make sure tire pressures are 14 PSI in front; 10
PSI in rear.
SIPE TO SIDE HOJUSTMEilT
1. Use a ruJer to make sure Flanges at rear of mower deck
are the same height from the ground on each side (Fig.
19).
2. if adjustment is required, snap out Access Cover on L,H,
side of tractor above Foot Rest (Fig, 18).
3« Move Attachment Handle to full "UP" position (Fig. 17).
4„ To lower right side of mower, loosen Nut "
b
" and screw
Nut "
a
" down on Adjustment Rod.
5« To lower left side of mower, loosen Nut ”
b
” and screw
Nut "A*‘ up on Adjustment Rod.
6,
Adjust until both rear mower flanges are the same height
above the ground. Tighten Nuts A and B securely.
Snap Access Cover in place.
FRQWT TO BEAR ADJiUSTMlWT
Move Attachment Handle to full "UP" position (Fig. 17).
After leveling side to side, measure R.H. Flanges at FRONT
AND REAR OF MOWER. The R.H. Front Flange should
measure 3/4'* lower than the R.H. Rear Flange (Fig. 19).
If adjustment is required, follow procedure below.
FIGURE 18
FIGURE 19
‘10-