Sears 917.25591 - Manual (Page 11)

1. TO RAISE FRONfoF MOWER ^ _
Loosen Nuts D *. Screw Nuts "c" up onto Suspension
Arms (Fig. 20). NOTE: SCREW NUTS "C” ON BOTH
SUSPENSION ARMS THE SAME NUMBER OF TURNS
SO MOWER WILL REMAIN LEVEL Tighten Nuts "O"
securely.
2. TO LOWER FRONT OF MOWER^
Loosen Nuts "c”. Screw Nuts "o" down Suspension Arms,
NOTE: SCREW NUTS " d " THE SAME NUMBER OF
TURNS so MOWER WILL REMAIN LEVEL. Tighten
Nuts C securely,
3. With mower deck at desired height, set Gauge Wheels ^Fig.
17) to lowest position without touching the ground.
Use Adjustment Handle to sat mower at the approximate
cutting height you need. Use Clevis Pins (Fig. 17) to set gauge
wheels at lowest point without touching the ground.
MOWER OPERATION
When ready to mow, lower Attachment Handle (Fig. 21)
to preferred mower height. Select a gear that allows mowing
at full throttle. This allows the mower blades to lift and cut
the grass efficiently.
MOWER ENGAGEMENT ■ ■I Vii K V hp.I I In.I v VJiTliVP lw>-f¥l I m IM f
Pull Clutch Switch (Fig, 22) out and up to engage clutch.
There will be an engine hesitation as the clutch engages.
DEPTH ADJUSTMENT
Fine adjustment of mower height is controlled by the Depth
Adjustment Knob. Turn clockwise ('^) to raise mower. Turn
counterclockwise (y*>| to lower mower (Fig. 22).
ADJUSTMENT
KNOB
FIGURE 22
■11 -