Sears 113.19771 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The foliowing parts are included with Model 113.197751.
Key
No.
1
2
3
Table of Loose Parts
Qty.
Leg...................................................................................... ^
Stiffener, L.H...................................................................
Stiffener, R.H...................................................................... 4
Loose Parts Bag Part No. 63752
(containing the follawing itemsT
- Screw, Truss Hd. 1/4-20 * 5/8 ................................... 40
- Lockwasher, 1/4 External ........................................... 40
- Lockwasher, 5/16 External ............................................ 4
^Nut, Hex 1/4-20 ............................................................. 40
- Nut, Hex Jam 5/16-18 ................................................... 4
- Nut, Hex 1/2-13 ............................................................. 8
- Foot, Leveling ................................................................ 4
- Screw, Hex Hd. 5/1B-18
X
5/8 ................................... 4
- Washer, 11/32 x 11/16 x 1/16 ....................................... 16
17-3/4"
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model 113.197751,
From among the loose parts, find the following Hardware:
40 Truss Head Screws, 1/4-20 x 5/8
40 Lockwashers, 1/4-External
40 Hex Nuts, 1/4-20
8 Hex Nuts, 1/2-13
4 Leveling Feet
Assemble the Legs as shown.
1.
Assemble Two (2) each of right and left hand Stiffeners
to the length shown using 1/4-20 x 5/8" truss head
screws, lockwashers and hex nuts.
2.
Attach the four (4) legs to the Stiffeners using 1/4-20
screws, lockwashers and nuts.
3.
Install leveling feet as shown. To level steel legs, loosen
nut on inside of leg and turn nut on outside to raise
o r
lower feet. Adjust all four levelers if necessary, and then
tighten nuts on inside of leg.
NOTE: These levelers are not intended for height
adjustment.
CAUTION: Leveling feet must be adjusted so the saw does
not rock AND so that the arm slopes slightly downward to
the rear so the carriage will not roll forward due to gravity.
o o
I o
STIFFENER
L.H .
STIFFENER
R.H.
21-1/4".
o O ' O O
STIFFENER
L.H.
STIFFENER
R.H,