Assembly and alignment – Sears 113.19771 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
assembly and alignment
BE
positive
switch
is
"OFF"
and
power
cord
unplugged
thru-out entire procedure.
REMOVE
CARRIAGE
STOP
SCREW,
LOCKWASHER
AND
TAG.
Read
and
understand
warning
tag
before
discarding.
LOCK ARM BEFORE PROCEEDING.
HOLDING
CARRIAGE
ASSEMBLY
WITH
BOTH
HANDS,
CAREFULLY
START
AND
SLIDE
THE
CARRIAGE ONTO THE TRACKS. The assembly must be
held parallel with the arm so that all four bearings slide
smoothly onto the arm, preventing any excessive strain on
bearings and track.
WARNING:
REINSTALL
CARRIAGE
STOP
SCREW
TO
PREVENT CARRIAGE FROM ROLLING OFF ARM.
Check
for
looseness
of
carriage
bearings.
Refer
to
"Adjusting
Carriage
Bearings"
in
"Adjustments
to
Compensate for Wear" Section.
REMOVE SHIPPING SCREWS AND DISCARD.
Use of pliers may be necessary.
VIEW OF UNDERSIDE OF MOTOR
SHOWING LOCATION OF TWO
SHIPPING SCREWS
REMOVE SAW BLADE.
1. Tighten carriage lock knob,
2.
Loosen guard clamp screw, remove guard.
3.
Motor shaft has left hand threads. Hold shaft wrench
and rotate arbor wrench down (clockwise).
4.
Remove shaft nut, outer collar, saw blade, and inner
collar. Set aside and out of the way,
11