Sears 113.19771 - Manual (Page 14)

2. Loosen (2) % — 20 Gib set screws on the left side at the
rear of the column support.
3. Elevate, and then lower the Arm: (al if the column
binds and elevation is difficult loosen two 5/16 - 18
plated bolts on front side of the column suppo.d until
you achieve smooth but firm elevation, (b) If the
column moves side-to-side within the column support,
tighten the two 5/16 — 18 plated bolts until movement
disappears - elevation should bo smooth and firm.
4. Now tighten the ¡2) Vi — 20 Gib set screws until no
noticeable rotational play exists between Column Tube
and Column Support.
5. Recheck elevation and re-adjust if necessary.
6. Replace Column Support trim.
STEP THREE
S Q U A R I N G C R O S S C U T T R A V E L (CARRIAGE
TRAVELS IN A STRAIGHT LINE).
1. Index but do not lock arm at 0*^ miter.
2. Install saw blade as shown. Motor shaft has left hand
threads.
NOTE: Do not overtighten arbor nut. Use the arbor wrench
to just "snug” it.
-INNER COLLAR
14