Sears 113.19771 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVE SKIDS FROM BASE
MOUNTING SAW
1.
From among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16-18 x 5/8
4 Lockwashers, 5/16 in. External Type
1 6 Washers, 11 /32 ID
8 Hex Jam Nuts, 5/16-1 8
2.
Place saw on legs so that holes in bottom of saw line up
with holes marked X in top of legs.
3.
Install screws, washers and nuts as shown.
If you mount the saw on any other Craftsman base or flat
bench, make sure Elevation Crank has proper clearance to
rotate. The saw must be bolted down. Position saw to slope
slightly rearward, so when the carriage is installed it will not
roll forward due to gravity.
LEG
R.H. 5TIFFENER
L.H. STIFFENER LEG
o o
(
d
0
/
X
—-----------------------------—---------------------------- -
X
0
, O
o
o
o
o
o
o
0
O
o
X
X
\
o
o l o
O o
0 O ooo
s
ATTACH ELEVATION CRANK.
Be sure setscrew is tightened on flat of shaft.
ELEVATE ARM TO ITS MAXIMUM HEIGHT.
Remove shipping block and discard.
10