Sears 831.159341 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
4.
Moch the Seot (28} to the Upright (9) with the two
1 /4'
X 5/8' Bolh (20) on
\
8}.
15.
Center one Pod Tube ( 2 2 ) in the Upright (9), and the
other Pod Tube in the Leg Developer (23), Slide the
four Small Pads (17) onto the ends of the Pod Tubes.
16.
Rest the Left and Right Pedols (75,
76]
on the hooks
at the lo>ver ends of the Resistonce Cylinders (84).
Moke sure that the ftooks are fully inserted info the
same slots under both Pedals.
i Plug the Transformer (39) into the jock locoted riear
the bottom of the Right Side Shield (12).
17. Moke sure that oil parts are properly tightened. The use of oil remoining ports will be exploined in ADJUSTING
THE CROSS TR4JNER e, beginning cm роде 8 of this owner's manual.
18.
Before using the CROSS TRAINER e, test the cables and H>e pulleys. Make sure that the cobles are in the grooves
in the pulleys. If the cables do not move smoothly over the pulleys, locate and correct the problem before using
I the CROSS TltAINER e. If the cables are not properly routed, they will be damoged when used.