Sears 831.159341 - Manual (Page 4)

ASSEMBLY
Assembly requires two persons. To assemble the CROSS TRAINER e, use the included videocassette or follow the
instructions below. Due to the weight of the CROSS TRAINER e, it should be ossembled in the location where it will be
used. Ploce oil ports in a cleared orea and remove the packing materials. Do not dispose of the pocking materials until
assembly is completed. Make sure to lower the resistance cylinders and pedals before beginning assembly; if the
resistance cylinders fall, they may damoge the side shields. Read each assembly step and examine eoch drawing
corefuily. Refer to the Part Identifìcation Chart occompanying this owners manual, to help identify the hordwore used in
assembly. Make sure that all parts are oriented as shown in the drawings.
The following tools [not included) are required for assembly; two 8* Adjustable Wrenches and a
Rubber Mallet | — i . A small amount of soopy water is also required.
1. Set the Front Bose
(7)
and the Rear Base (8) on the
Door as shown. Turn the Rear Base so the indented
holes are toward the floor.
Insert seven 3/8' x 2 1 /2' Carriage Bolts [1) up
through the indicated holes in the Front and Rear
Boses (7, 8).
2.
With the help of a second person, set the Tower
Frame (10) neor the Indicated ends of the Front and
Reor Boses (7,8). The Tower Frame must be turned
so the Pedals (75,76} ore on the same side os the
extension on the Front Bose. Raise the Tower Frame
and lower it onto the hvo indicated 3/8' x 2 1 /2'
Corrioge Bolts (1} in the Rear Base.
3. Roise the front of the Tower Frame (10) and lower it
onto the two indicated 3/8' x 2 1/2' Carrioge Bolts
(1) in the Front Bose (7).
Adjust the position of the Tower Frame (10) so the
four indicoted 3/8' x 2 1/2' Corrioge Bolts (1) are
centered in the slotted holes in the Tower Frame.
Thread a 3/8' Nut (2J with a 3/8' Lockwosher (3)
onto each Corrioge Bolt. Do not tighten the Nuts
yet.
Extension
Extension