Viconics VT7607 Installation Manual - Manual (Page 13)

13 | PIR Ready VT76x7 Series-Installation Guide
Local keypad interface
Each of the sections in the menu is accessed and configured using 5 keys on the
Terminal Equipment Controller cover.
The priority for the alarms is as follows:
The YES key is used to confirm a selection, to move onto the next menu item
and to manually scroll through the displayed information.
The NO key is used when you do not desire a parameter change, and to
advance to the next menu item. Can also be used to toggle between heating
and cooling setpoints.
The MENU key is used to access the Main User Menu or exit the menu.
The down arrow key is used to decrease temperature setpoint and to adjust
the desired values when configuring the Terminal Equipment Controller.
The up arrow key is used to increase temperature setpoint and to adjust the
desired values when configuring the Terminal Equipment Controller.
When left unattended for 45 seconds, the display will resume automatic status display
scrolling.
To turn on the back light, press any key on the front panel. The back lit display will turn off
when the Terminal Equipment Controller is left unattended for 45 seconds
Sequence of user menu:
Override
Resume
Temperature
setpoints
Humidity
setpoints
System
mode
setting
Fan
mode
setting
Schedules
setting
Clock
setting
Schedule
hold
Override
schd Y/N Temperat
Set Y/N
Humidity
Set Y/N
Sys
mode
set
Y/N Fan
mode
set
Y/N
Schedule
set Y/N
Clock
set
Y/N
Schedule
hold Y/N
Appears
only in
unoccupied
mode Appears
only on
stand-alone
(Network
Ready)
models
Cancel
ovrd Y/N
Appears
only in
override
mode