USL CMS-2200 Manual - Manual (Page 23)

Page
23
of
89
¨ Install
the
panel
tamper
label
(Barco
projectors
only)
Barco
projectors
require
that
a
tamper
label,
which
is
included
with
the
CMS-­‐2200
is
attached
across
the
edge
of
the
CMS-­‐2200
and
the
side
panel
of
the
projector.
The
label
will
provide
security
detection
if
the
CMS-­‐2200
is
removed.
¨ Replace
cover
Follow
the
manufactures
instructions
for
reinstalling
the
projector
panels.
¨ Install
the
projector
Ethernet
cable.
Reinstall
the
projector’s
Ethernet
cable.
¨ Install
AES
audio
cable
Install
the
AES/EBU
audio
cables
to
the
audio
ports.
Refer
to
Table
2-­‐1
and
Figure
2-­‐2
for
connection
information.
Standard
Ethernet
(Cat
5
or
Cat
6)
cables
can
be
used
to
provide
the
connection
to
USL
audio
processors
like
the
JSD-­‐100
and
JSD-­‐60.
¨ Install
Automation
Network
cable
(optional)
If
a
CMSA-­‐100
will
be
used
in
the
system,
connect
the
automation
cable.
For
the
CMSA-­‐100
a
standard
Ethernet
(Cat
5
or
Cat
6)
cable
may
be
used
for
the
connection.
The
CMS-­‐2200
comes
with
built
in
automation
cues
to
support
the
CMSA-­‐100.
For
GPIO
interfaces
refer
to
Table
2-­‐2
and
Figure
2-­‐2
for
wiring
details.
The
CMS-­‐2200
comes
with
built
in
automation
cues
to
support
the
GPIO
interface.
¨ Install
Management
(Ethernet
automation)
Network
cable
(optional)
If
the
system
requires
a
control
network
or
Ethernet
automation
devices,
install
the
Control
network
cable
into
the
AUX
port
on
the
front
of
the
CMS-­‐2200.
Refer
to
Figure
2-­‐1
for
the
location
of
the
AUX
port.
¨ Install
Media
Network
Ethernet
cable
(optional)
For
systems
that
have
a
Data
network,
typically
used
for
transferring
content
between
systems,
install
the
data
network
Ethernet
cable
into
data
port
B
on
the
CMS-­‐2200.
Refer
to
Figure
2-­‐1
for
the
location
of
the
data
B
port.
¨ Perform
Marriage
procedure
Follow
the
manufacturer’s
marriage
procedure
to
marry
the
CMS-­‐2200
to
the
projector.