TeeJet UniPilot - Manual (Page 9)

7
98-05226-ENUS R4
UniPilot
®
six simple steps to Get Going!
1. Assemble Universal Mounting Bracket Kit on steering column so that it can be adjusted with the installation of the
UniPilot ESM.
• See page 8 for recommendations for your specific steering column.
2. Install UniPilot ESM and check spacing.
• Attach the UniPilot ESM to the mounting bracket. The steering wheel should rotate freely around when the UniPilot
ESM is in the Operating Position. When in the Standby Position, there should be 1.6 in. / 40 mm of space between the
UniPilot contact wheel and the vehicle's steering wheel.
3. Secure or firmly tighten the mounting parts to Steering Column.
4. Connect Electronics.
5. Program Specific Settings on Guidance Console.
6. Activate & GO!
NOTE: All references to left and right are stated as if the user is seated in the
driver’s seat.
All references to front and back are stated in relationship to the front and
back of the vehicle.
assemble Mounting Bracket
The purpose of the mounting bracket is to securely mount the UniPilot ESM (Electric Steering Motor) to the steering column and keep the UniPilot
ESM from rotating around the steering wheel.
Depending on the shape of your steering column, a different mounting bracket configuration may be needed. The following page illustrates a few
examples of installation methods. If you do not see an example that illustrates your vehicle's requirements, please contact your dealer or TeeJet
Customer service representative for clarification on your specific vehicle's installation.
1. Assemble Universal Mounting Bracket Kit on steering column so that it can be adjusted with the installation of the UniPilot ESM.
The mounting bracket will be secured after the UniPilot ESM is assembled.
Figure 1-3: Mounting Bracket Parts
Standby Position Operating Position
1.6 in. / 40 mm of space