TeeJet Matrix Pro 840G User Manual - Manual (Page 76)

69
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
options
Options allows the operator to select between Simple or Advanced
Job Mode.
WARNING! Changing job modes deletes all internal job data.
1. Press DATA MANAGEMENT side tab .
2. Press
Options
.
3. Press DOWN arrow to access the list of options.
4. Select:
►Simple – Only bounded and applied area are displayed on the
home screen. Only the current job is available for saving in
Reports. Job specific information input with Fieldware Link is
not available.
►Advanced – Client, farm, field, job, bounded area and applied
area are displayed on the home screen. All saved jobs can
be saved in Reports. With Fieldware Link, a user can input
client, farm and field data as well as duplicate/edit jobs for
reuse of boundaries and guidelines.
5. "Changing job modes requires deleting all job data. Do you wish
to change modes?"
Press:
►Yes – to make the change
►No – to keep the current setting
6. Press RETURN arrow or DATA MANAGEMENT side tab
to return to the main Data Management screen.
NOTE: The job stored in Reports is not available for selection (icons
greyed out) when a job is active/started. Stop the current job
to enable the Reports function.
Figure 6-81: Options - Change Job Mode
data
Manage data Transfer
Options Reports
data->Options
Job Mode Advanced
Simple
Advanced
data->Options
Job Mode Advanced
Changing job modes requires
deleting all job data.
do you wish to change
modes?
Yes No