TeeJet Matrix Pro 840G User Manual - Manual (Page 27)

20
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
Implement Setup
When a SmartCable or Section Driver Module (SDM) is not present
only a single boom setup is available. Configurations for Overlap,
Delay On and Delay Off will not be available, and Number of
Sections will be set to one.
1. Press CONFIGURATION side tab .
2. Press
Implement
.
3. Select from:
►Number of Boom Sections # – establishes the number of
boom sections
►Guidance Width – establishes the width between
guidelines
►Spray Width – establishes the width of each boom
section for a total spray width
►Overlap – determines the amount of overlap allowed
►Delay On – establishes the timing for the boom section
valves to switch on
►Delay Off – establishes the timing for the boom section
valves to switch off
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.
NOTE: Press or to switch between Implement setup screens.
Figure 3-15: Implement Setup Options
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config->implement
Num Sections
Spray width
Guidance width 60.00 ft
144.00 ft
15
Config->implement (2)
Overlap
delay Off
delay On 1.00 s
1.00 s
50%