TeeJet Matrix Pro 840G User Manual - Manual (Page 57)

50
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
Options: Steering Wheel Sensor
Steering wheel sensor selects whether the sensor used to
automatically disengage FieldPilot is magnetic or pressure based
when the steering wheel is turned. Check your specific configuration
to determine if a Steering Wheel Switch Kit or a Pressure Sensor is
being used.
The UniPilot is not affected by this setting.
1. Select
Options
.
2. Press DOWN arrow to access the list of options.
3. Select:
►Magnetic
►Pressure
Figure 6-39: Options: Steering Wheel Sensor
Config-> AutoSteer
Enabled
Valve Setup Steering Settings
Valve Test Valve diagnostics
Angle Sensor Options
On
Config-> AutoSteer->Options
Steering wheel Sensor Magnetic
Magnetic
Pressure
Angle Sensor
Angle Sensor is used to establish the Steering Angle Sensor (SAS)
as the primary feedback sensor for auto steering, calibrate the SAS
and set an offset adjustment.
1. Select
Angle Sensor .
2. Select if the angle sensor is
►Enabled
►Disabled.
3. Select from:
►Calibrate Sensor – sets the turn rate when steering the
vehicle left and right.
►Offset Adjustment – adjusts the path of travel to the
established guideline.
Figure 6-40: Steering Angle Sensor
Config-> AutoSteer
Enabled
Valve Setup Steering Settings
Valve Test Valve diagnostics
Angle Sensor Options
On
Config-> AutoSteer->Angle Sensor
Angle Sensor
Calibrate Sensor
Offset Adjustment
Enabled