TeeJet CenterLine 2.0 - Manual (Page 45)

CenterLine
Software Version 2.00
CenterLine 39
CenterLine Real-Time Operation
A+ Feature
At any time after a guideline is created, the guidance line can be shifted to the current position by
activating the “A+” feature. The heading (and shape, if in curved mode) of the original guideline is
maintained, but the A/B line is shifted to the vehicle location. Scroll the real-time menu until
is displayed and Press Enter to activate the shift.
Area Determination
The area of the current job or field is important information. CenterLine allows the determination of
the area of a field by driving the perimeter of the field. This can be conveniently done while driving
the first headland circuit in Headland mode.
To determine the area of a field, scroll the real-time menu until is displayed (See
Figure 44 on page 39) and Press Enter. The lightbar displays or . Using Up or
Down, select the side of the swath or implement that is closest to the field boundary. Press Enter
to start area calculation. The lightbar displays < Map BND> or > . When ready to
close the boundary, scroll the real-time menu (Figure 41) until is displayed. Press Enter
to close the boundary and determine the area. Pressing inserts a line between the start-
ing location and the current location and uses that shape to determine area.
The area is automatically determined when the vehicle drives within 4.5 meters (15 feet) of the
starting point.
The bounded area is displayed on the lightbar as a part of the guidance message stream for three
minutes and when stopped in an “applied” area.
If a bounded area has already been determined, the menu item is present. Pressing
Enter at the level displays the current bounded area value.
Figure 43: Area Determination Flow Diagram
Figure 44: Area Determination Flow Diagram
A+