TeeJet CenterLine 2.0 - Manual (Page 27)

CenterLine
Software Version 2.00
CenterLine 21
CenterLine Setup
Status
If using a Swath Manager 5 the setting will be removed from the menu setup.
The setting is used to auto detect implement status. When the status detect is properly
implemented, the CenterLine detects whether product delivery is on or off, based on the vehicles
product on/off switch. See “CenterLine Product Kits” on page 9 -12 for location of status connect
(boom sense) wiring.
NOTE: When is set to , +12V must be supplied to the boom sense wire
when booms are on. If this is NOT done applied area detection will NOT work. Reference
the CenterLine wiring tips document 98-01095.
To adjust the Status setting, go to Guidance setup, scroll with Up or Down until is dis-
played in the text window, and press Enter. Using Up or Down, scroll between the and
settings until the desired setting is displayed in the text window. Press Enter to save the
setting and return to the Guidance setup menu.
Figure 26: Selecting the Status Setting
Setting Description
OFF No Status Detect implemented. Default setting.
ON Status detect assumes a single swath centered on the vehi-
cle.
Table 4: Status Settings