TeeJet CenterLine 2.0 - Manual (Page 23)

CenterLine
Software Version 2.00
CenterLine 17
CenterLine Setup
Delay
Set a delay in seconds. This will act as a look ahead to turn booms off and on when entering and
exiting an applied zone
.
Entering Applied Zone
When entering an applied zone the boom width based on the %overlap must be in the applied
zone the seconds entered in the Delay setup before the boom will be shut off.
Exiting Applied Zone
When exiting an applied zone this setting acts as a look ahead and turns the boom on prior to exit-
ing an applied zone based on the seconds entered in Delay Setup.
Figure 18: Delay