TeeJet IC18 SPREADER JOB COMPUTER - Manual (Page 38)

33
98-05173 R1 US
ISOBUS Job Computer : IC18 Spreader NA
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
CHAPTER 4 – OPERATION MODE
The Operation Screen accesses the working aspects of the IC18 including boom section control, rate
control and trip/count/application information.
NOTE: Settings are automatically saved when selected.
NOTE: The menu structure on your display might vary from the one displayed in this User Manual
depending on the virtual terminal being used.
NORTH AMERICA OR EUROPEAN CALCULATION MODE
The IC18 job computer is programed to calculate calibrations based on North American or European methods.
◄North America – Gate Height is calculated into the product application and calibrations will be based on pulses
per volume.
◄European – Gate Height is NOT calculated into the product application and calibrations will be based on
volume per pulse.
This setting has been established before leaving the factory, but it can be changed after purchase with assistance
from TeeJet Technologies Customer Service or your local dealer through the OEM setup menu options.
OPERATION MODE OVERVIEW
Information on the Operation screen will vary depending on the parameters set by the user and the OEM.
Figure 4-1: Operation Mode Screen Overview
C n t 1
0 . 0 5 0 0
2 9 8 . 2 t o n
0
1 . 1 4 a c
1 3 11
l b / a c l b / m i
0 R P M R P M
R o l r S p n r
Count Number
Remaining Bed Content
Speed/Application Information
Alert Warning
Application On/Off Indication
Roller RPM
Applied Volume Applied Area
Spinner RPM
Extra Key Spaces
Home Key
Information Key
Master Screen Key
Start/Stop Key