TeeJet IC18 SPREADER JOB COMPUTER - Manual (Page 32)

27
98-05173 R1 US
ISOBUS Job Computer : IC18 Spreader NA
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
OEM
The OEM setup menu is password protected and the settings in this menu are directly related to the fitted OEM
equipment. To obtain an access code, contact your local dealer or TeeJet Technologies Customer Service.
To access the OEM screens:
Figure 3-26: Machine to OEM
Figure 3-27: OEM Unlock
1. From the Main Setup Screen , select MACHINE.
2. Select OEM.
3. Select the Access Code Entry Box to the right of the
menu option.
4. Use the number pad or slide bar to enter the access
code.
5. Select the ACCEPT KEY to complete the unlock
process
6. Select from:
►Sensors – used to establish the parameters for
Spinner RPM, Spinner RPM Revolution, Hydraulic
Motor RPM Revolution, and Weighing systems
►Actuators – used to select the type of valve used to
control the spreader belt
►Bed Size – used to establish the maximum load
capacity of the spreader
►User Interface (VT) – used to establishes the
displayed tolerance for application rate
►Regulator Configuration – used to establish:
◄ Regulator Test – used to verify the regulation
control matches theory and actual settings.
◄ Valve Configuration – sets the control settings
for the regulation valve.
◄ PID Parameters – sets the course and fine
adjustments of the regulation valve.
►Calibration RPM – used to program the desired
roller RPM, the bed chain speed, used during the
calibration process
►Program Modes – used to designate various
options that impact system functions including
program style, calibration type, flow factor, step
persentage and fast empty