TeeJet IC18 SPREADER JOB COMPUTER - Manual (Page 27)

22
www.teejet.com
ISOBUS Job Computer : IC18 Spreader NA
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Filling
Filling establishes the amount of material remaining in the bed.
NOTE: The size of the tank is established in the OEM menu. This is the number that will repopulate when the Full
Bed Key is pressed.
Figure 3-16: Filling
Figure 3-17: Operation
Amount Remaining
Actual Content displays the current volume of content in
the tank.The volume can be manually adjusted.
• To adjust the volume, use the number pad or slide
bar.
Full Bed
Full bed returns the amount remaining value to the
maximum volume of the bed.
• To reset the Amount Remaining value, press the
FULL BED KEY .
Operation
Operation establishes Speed Source and Simulated
Speed.
Speed Source
Speed Source selects whether to base the machine’s
speed on input from the CAN, an Implement or a
Simulated source. Selecting “Implement” will allow for
the configuration of pulses per 300 feet / 100 meters.
Selecting “Simulated” will allow for simulated speed to be
entered using the “Edit Value” option. Selecting “CAN”
allows for speed being supplied by the ISOBUS CAN
(usually from the TECU) to be used.
• To select the Speed Source, select an option
from the drop down menu or use the UP/DOWN
ARROWS to highlight the option.
NOTE: If “Implement” is selected, refer to the Calibrations section for further instructions.
Simulated Speed
Simulated Speed establishes a speed to be used when using the Simulated Speed source.
• To select the Simulated Speed, use the number pad or slide bar.