TeeJet IC18 SPREADER JOB COMPUTER - Manual (Page 31)

26
www.teejet.com
ISOBUS Job Computer : IC18 Spreader NA
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Alarm Configurations
Figure 3-25: Alarm Configurations
Alarm Configurations establishes alarms on or off as well
as sets their trigger level.
Amount Remaining Alarm On/Off
The Amount Remaining Alarm will appear if the hopper
amount has reached the low limit level entered. Select
either “On” to activate the alarm, or “Off” to deactivate the
alarm.
• To select the Amount Remaining Alarm mode, select
an option from the drop down menu or use the UP/
DOWN ARROWS to highlight the option.
Amount Remaining Trigger Level
Amount Remaining Trigger Level establishes the low limit
that will trigger the Amount Remaining Alarm.
• To select the Amount Remaining Trigger Level, use the number pad or slide bar.
CAN Speed Source Timeout
CAN Speed Source Timeout establishes the number of seconds the system will continue to run on CAN speed
without receiving CAN input before the alarm triggers.
• To select the CAN Speed Source Timeout time, use the number pad or slide bar.
Active Trip Count Information
The Active Trip Count Information Alarm will appear on power up to identify to the user which trip counter is active
and that this specific counter will be used for storing work data. Select either “On” to activate the alarm, or “Off” to
deactivate the alarm.
• To select the Active Trip Count Information alarm mode, select an option from the drop down menu or use the
UP/DOWN ARROWS to highlight the option.