Sonics E-Press - Manual (Page 13)

Sonics E-Press Manual Page 13
GX Power Supply
1. J1, a round, 12-pin RF cable that connects the welding press to the power supply.
2. J2, an actuation cable that connects the power supply to a trigger source (press cable or external trigger
source.) Refer to wiring diagrams at the back of this manual.
3. J4 Serial Output***
4. J5 External I/O
5. The power line cord that plugs into the appropriate electrical outlet.
6. Fuse (0.5 amp - internal low voltage)
7. Line fuse
8. Line fuse
***NOTE: The RS-232 cable connected between the GX Power Supply and the PC must be a null modem
cable (crossover).