Sonics VCX750 (Serial No."Y through "AB")" User Manual
Sonics Equipment
U S E R ’ S G U I D E
AUTOTUNE SERIES
HIGH INTENSITY ULTRASONIC PROCESSOR
WITH TEMPERATURE CONTROLLER
MICROPROCESSOR CONTROLLED (SERIAL NO. "Y" OR HIGHER)
500 WATT MODEL • 750 WATT MODEL
TABLE OF CONTENTS
Warranty
Important Safeguards
Low Surface Tension Liquids – Organic Solvents
SECTION I – INSTALLATION
Inspection.......................................................................................1
Electrical Requirements ................................................................1
Installing the Ultrasonic Processor ................................................1
SECTION II – OPERATION
Principles of Ultrasonic Disruption.................................................2
Functions of Controls, Indicators, and Connectors.......................3
Preparation for Use ........................................................................5
Using the Ultrasonic Processor .....................................................8
SECTION III – SERVICE INFORMATION
Return of Equipment ....................................................................17
SECTION IV – OPERATING SUGGESTIONS
AND TECHNIQUES .....................................................................20
The Ultrasonic Processor supplied with this instruction manual is constructed of the finest
material and the workmanship meets the highest standards. It has been thoroughly tested and
inspected before leaving the factory and when used in accordance with the procedures
outlined in this manual, will provide you with many years of safe and dependable service.
REV 5-08