Remove a lens mount, Red motion mount operation guide – RED MOTION MOUNT User Manual

Page 9

RED MOTION MOUNT OPERATION GUIDE

955-0013, REV-E | 9

REMOVE A LENS MOUNT

REQUIRED TOOL: T20 Torx

driver

1. Turn off the DSMC.
2. Attach the DSMC to a stable platform or position the DSMC on a clean and level work surface so that the

lens mount screws are accessible.

3. Remove the lens, as well as any DSMC modules, cables, or other accessories that might interfere with

removing the lens mount.

4. Loosen and remove the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern) using a

T20 Torx driver.
NOTE: Screw removal may require a large handle T20 Torx driver and additional leverage.

5. Remove the lens mount from the DSMC.

NOTE: When the MOTION MOUNT is not in use the rear glass is blue. During operation the rear glass turns yel-

low. If you remove the MOTION MOUNT shortly after operation, the glass will be yellow and develop blue spots.

As the glass cools, it will return to its original blue color. This color transition is typical behavior.

Remove the lens mount screws

Remove the lens mount