RED MOTION MOUNT - Manual (Page 24)

COPYRIGHT © 2014 RED.COM, INC
RED MOTION MOUNT OPERATION GUIDE
955-0013, REV-E | 24
STORAGE INSTRUCTIONS
Follow these instructions to protect the RED MOTION MOUNT ® when not in use:
Protect the MOTION MOUNT while not in use by replacing the DSMC Mount Body Cap and the DSMC
Mount Back Cap.
Store the MOTION MOUNT in a clean, dry environment.
CLEAN MOTION MOUNT GLASS
As with all optical glass, any type of physical contact with the glass may scratch or damage the surface. RED
recommends that you clean the MOTION MOUNT glass using physical contact only if absolutely necessary.
Before cleaning the MOTION MOUNT glass with swabs or wipes and a cleaning solution, ALWAYS use an air
bulb to remove any solid particles. Cleaning the MOTION MOUNT glass without removing solid particles in-
creases the risk of scratching the optical surface.
WARNING: Handle the MOTION MOUNT glass carefully. Failure to follow proper cleaning instructions may scratch
or damage the optical surface.
GENERAL CLEANING INSTRUCTIONS
Avoid using the MOTION MOUNT in dusty or hazardous environments.
Avoid physical contact with the glass.
DO NOT rinse the MOTION MOUNT or immerse it in water.
DO NOT use compressed air to clean the MOTION MOUNT.
DO NOT use soaps, detergents, ammonia, alkaline cleaners, or abrasive cleaning compounds to clean the
MOTION MOUNT.
DO NOT apply cleaning solution directly to the MOTION MOUNT glass.
DO NOT use an excess of cleaning solution.
DO NOT reuse swabs or wipes.
AIR BULBS
Use a rubber air bulb to remove any solid particles, such as dirt or dust. Use an ionized air bulb to remove solid
particles as well as static build-up.
WARNING: DO NOT use compressed air to clean the MOTION MOUNT. The high pressure may damage the glass,
and some compressed air can leave an oily residue, which may be difficult to clean.
04
MOTION MOUNT
MAINTENANCE