PRG Bad Boy Field Service Manual User Manual

Page 88

BAD BOY

SPOT LUMINAIRE FIELD SERVICE MANUAL

Step

7. Move Pan Cable Routing Plate out of the way enough to access belt and pulley.

Step

8. At Pan Drive Assembly, loosen (but do not completely remove) four 10-32 x 5/8" socket head screws. This

will begin to loosen the belt.

Step

9. Release belt tension by loosening two belt adjustment screws and slip belt off of pan pulley (Figure 3-41).

Step 10. Remove four 10-32 x 5/8" socket head screws and two #10 flat washers from Pan Drive Assembly.

Step 11. At Bus Bar,

remove

screw on left-hand side and

loosen

screw on right-hand side. Rotate Bus Bar up and

out of the way. (This will make it easier to remove the Pan Drive Assembly.)

Step 12. Remove Pan Drive Assembly from yoke.

Step 13. Replace Pan Drive Assembly by doing steps in reverse.

Step 14. Set proper belt tension. Refer to

Figure 3-40: Removing Pan Drive Assembly (View 1)

Pan Drive Assembly

10-32 x 5/8"
PFZ Screw (5)

Pulley

Belt

10-32 x 5/8"
Soc Cap Screw (2)

#10 Flat Washer (2)

DETAIL A

Pan Cable
Routing Plate