Replacing the pan/tilt controller pcb – PRG Bad Boy Field Service Manual User Manual
Page 84

76
BAD BOY
®
SPOT LUMINAIRE FIELD SERVICE MANUAL
Replacing the Pan/Tilt Controller PCB
Parts:
24.9812.0765
1 EA
PCB ASSY, CONTROLLER PAN/TILT
Tools:
#2 Philips screwdriver
WARNING:
Remove power from luminaire before performing any maintenance procedures.
CAUTION:
Always use anti-static precautions when working with PCBs.
To replace the Pan/Tilt Controller PCB:
Step
1. Remove power from luminaire and allow components to cool for at least 5 minutes.
Step
2. At Tilt Yoke Leg, remove Yoke Cover.
Step
3. At Pan/Tilt Controller PCB, disconnect all cables.
Step
4. Remove Pan/Tilt Controller PCB by removing four 6-32 x 5/16" PPZ screws (Figure 3-37).
Step
5. Replace Pan/Tilt Controller PCB by doing steps in reverse.
Figure 3-37: Removing Pan/Tilt Controller PCB
Pan/Tilt
6-32 x 5/16"
PPZ Screw (4)
Controller PCB
CAUTION:
Use anti-static precautions
when working with PC boards.