Routine maintenance, Removing the head covers – PRG Bad Boy Field Service Manual User Manual
Page 38

30
BAD BOY
®
SPOT LUMINAIRE FIELD SERVICE MANUAL
ROUTINE MAINTENANCE
Removing the Head Covers
To access some interior head components, one or both of the Head Covers may need to be removed.
Parts:
21.9812.0630
2 EA
ASSY, HEAD COVER
Tools:
#2 Philips screwdriver (manual screwdriver only)
To remove Head Covers:
Step
1. At Head Cover, remove two 8-32 x 3/8" PPB screws (Figure 3-2).
Step
2. Remove Head Cover from luminaire.
Figure 3-2: Removing Head Covers
CAUTION:
DO NOT use a power screwdriver when re-installing the 8-32 x 3/" PPB screws. This may
damage the hole threads.
Use a manual screwdriver only!
Step
3. Replace Head Cover as follows:
a.
Set cover in place and slide rear corners under lip of Aft Cover.
b.
At front of Head Cover, press with equal pressure on both sides until leading edge of cover snaps into
place under front ring casting. (You will hear a "pop" when the cover snaps into place.)
c.
Using manual #2 Philips screwdriver, re-install screws.
R2 / Designer Wheel
Head Cover
R1 Head Cover
8-32 x 3/8" PPB
Screw (2 ea)
Aft Cover
CAUTION:
Hand tighten only. DO NOT use a
power tool on Head Cover screws.
Front
Ring
Casting