PRG Controlling VARI-LITE Equipment Using DMX 512 - Manual (Page 80)

DMX512 R EFERENCE G UIDE
7 2 02.3004.0300.54
Series 300 Floor Mounting
A Series 300 luminaire may be mounted in an upright floor position using a Series 300 floor stand. The
floor stand (22.9634.0161) includes all necessary hardware as shown in
Figure 3-10 .
To install floor stand:
Step 1. Orient pigtail cable as shown in
Figure 3-10 DETAIL B and rotate pan tube accordingly.
Step 2. Secure pivoting legs to pan tube using, on each pivoting leg, one 5/16-18 bolt and nut; with
two clutch disc springs, and one 1/4" flat washer between the bolt and the leg, one 1/4" flat
washer between the leg and the pan tube. Be sure to install disc springs with concave
surfaces facing the flat washer.
Step 3. Tighten nuts and bolts until there is proper tension: just enough so pivoting legs stay in
place, but not so much that the legs don’t pivot. See Figure 3-10 DETAIL A.
Figure 3-10: Installing Floor Stand
Pigtail Cable
5/16-18 x 1" Grade 5 Bolt (one per leg)
1/4" Flat Washer (two per leg)
Clutch Disc Spring
5/16-18 Nut w/ Nylon
PIVOTING LEG
FIXED LEG
PIVOTING LEG
Insert (one per leg)
(2 per pivoting leg)
FIXED LEG
PIVOTING LEG
PIVOTING LEG
Disc springs should be installed
with concave surfaces facing down
Pivoting legs should
be installed so that
they pivot, yet stay in
place after opening
FIXED LEG
PIVOTING LEG
PIVOTING LEG
DETAIL A DETAIL B
S300 Floor Stand Assembly
(22.9634.0161)
Rubber Bumper (3)
1/4" Flat Washer (two per leg)