Philips LC3500G199 - Manual (Page 39)

T ips if S omething isn ’ t W orking
Y) lease malce these simple checks before cahingfor
service. These tips can save you time and
money since charges for Projector installation and
adjustment of customer controb are not covered
under your warranty.
NO POWER
NO PICTURE
NO SOUND
REMOTE DOES NOT WORK
YOU CAN'T ’ESCAPE» FROM
A MENU
WRONG MENU APPEARS
THE ERROR LED BLINKS
ALL THE TIME
and
MESSAGE "REPLACE
PROTECTION LAMP"
THE ERROR LED AND ONE
OR TWO OTHER LEDS
BLINKS ALL THE TIME
(See page 5)
SET DOES NOT START
IMMEDIATELY
This Projector is equipped with protective circuitry that shuts the Projector
OFF in case of moderate power surges. Should this occur turn the Projector
back ON by pressing the POWER ON/STAND BY button, or unplug and
then replug the power cord at the AC outlet.
This feature is not designed to prevent damage due to high voltage, such as
lightning, which is not covered by your warranty.
Check the Projector power cord. Unplug the Projector, wait 2 minutes, then
reinsert plug into outlet and push POWER button again.
Check main power switch on back of Projector.
Check if the front grill is mounted properly.
Check PICTURE SELECT display for correct position. Using the VCR/AUX
position without a signal source will result in a blank screen.
Check the VOLUME buttons.
Check the MUTE button on the remote control.
Check the INT.(ERNAL)/EXT.(ERNAL) speaker switch on the rear of the
Projector. EXT. position cuts sound of the Projector’s internal speakers off.
Check battery.
Clean the remote and the remote sensor window on the Projector.
Press EXIT on the remote control. If that doesn't work, press the PCWER
CFF switch on the back of the Projector and immediately SWITCH ON
again.
If the DATA menu appears, go to page 34 for instructions on how to exit
DATA mode.
If the MAIN menu appears, go to page 25 for instmetions on how to enter and
control DATA mode adjustments.
The lamp needs changing.
Go to page 37 for instructions on how to do this.
There is a problem inside the set.
Don't try to fix it yourself; call your dealer for help.
Maybe the set 'ran' too hot. Check if ventilation slots are blocked.
Check if the lid for the lamp compartment is closed properly.
If you try to restart the set a short time after switching it off, it is possible that the
lamp does not turn on immediately. In this situation the POWER button light
blinks. The set will restart automatically within a few minutes.
If the set does not restart within 2 minutes, it will switch off and the error LED starts
blinking. Wait until the blinking has stopped and switch on the set again.
If the set does not start within 2 minutes, replace the lamp.
If the set still does not start, please contact your dealer.
39