Lamp screen, Top of projector, Eplacing – Philips LC3500G199 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
R
eplacing
T
he
L
amp
T
he lamp used as the light source in your
Projector will eventually have to be replaced.
Shordy after 6,000 hours of viewing, you will see a
warning display on your screen:
FOR BEST PERFORMANCE
PLEASE REPLACE LAMP.
RESET OPERATING HOURS TIMER
When you see this warning, the lamp should be
replaced as soon as possible to restore brightness
and to avoid sudden bum-out.
FOR BEST
PERFORMANCE
PLEASE REPLACE LAMP
RESET OPERATING HOURS TIMER
SEE USER MANUAL
LAMP Screen
BEGIN
Switch off your Projector and unplug
the power line.
Wait for the lamp to cool. THIS IS
IMPORTANT. In operation the lamp mns
very hot. You can bum yourself severely if you
handle the lamp when it is hot.
Give the screw on the lid a quarter
turn to the left and lift the lid.
Top of Projector
Ф:
Remove the 2 screws fixing the lamp.
Take the spare lamp out of the box and remove
the plastic bag.
Pull the lampconnector from it's base by
moving it to the left.
Remove the old lamp house by pulling it by the
top and lift out the old lamp. Discard it by
putting it in the trash can. DO NOT PUT IT
IN A FIRE.
<$>
Insert the new lamp house.
Push the lamp connector onto its base until
you feel a slight ‘click.
1^^^ Important
Do not forget to fix the anti-interference wire
with the screw after replacing the lamp house.
(Continued on next page)
37