NM Engineering 83.159.4300.72 - Manual (Page 19)

Step 7 Step 7 Step 7 Step 7 Step 7
A
A A A Attach S ttach S ttach S ttach S ttach Stainless S tainless S tainless S tainless S tainless Steel B teel B teel B teel B teel Brake Line rake Line rake Line rake Line rake Line
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 19
Install the caliper end of the stainless steel brake
line by first placing a copper crush washer on
either side of the banjo fitting, then inserting
the banjo bolt into the caliper.
Note: The orientation of the banjo fitting Note: The orientation of the banjo fitting Note: The orientation of the banjo fitting Note: The orientation of the banjo fitting Note: The orientation of the banjo fitting
should be as shown in the photograph to the
should be as shown in the photograph to the should be as shown in the photograph to the should be as shown in the photograph to the should be as shown in the photograph to the
left, with the brake line pointing upward to-
left, with the brake line pointing upward to- left, with the brake line pointing upward to- left, with the brake line pointing upward to- left, with the brake line pointing upward to-
war
war war war ward the bleed scr d the bleed scr d the bleed scr d the bleed scr d the bleed screw ew ew ew ew.....
Torque the banjo bolt to appr appr appr appr appro oo o oximately 14 lb- ximately 14 lb- ximately 14 lb- ximately 14 lb- ximately 14 lb-
ft ft ft ft ft, using a 14mm wrench or socket. Do not use
a torque wrench, as overtightening the bolt can
strip the aluminum threads, causing irreparable
damage to the caliper.
Copper
crush washers
Banjo bolt
Slide the grommet on the stainless brake line
into the bracket on the strut, and apply a cable
tie, as shown in the photograph to the right, to
hold it in place.
Once the grommet is firmly secured, trim the
excess from the cable tie.