NM Engineering 83.159.4300.72 User Manual

Page 17

Install the caliper onto the adapter bracket, ori-
enting it so that the bleed screws are positioned
on the top side of the caliper.

Slide the brake pads into position within the
caliper, taking care to ensure that the friction
side of each pad is facing the rotor.

SStep 6 (Cont

tep 6 (Cont

tep 6 (Cont’’’’’d.)

d.)

IIIIInstall C

nstall C

nstall Caliper and P

aliper and P

aliper and Pads

ads

3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 17

(Yes, the

es, the

es, they hav

y hav

y have been installed backwar

e been installed backwar

e been installed backward be-

d be-

fore!)

Take care to ensure that the caliper is square and
evenly started on both studs. It may be neces-
sary to use a mallet to gently tap the caliper into
position.

Install the Jet nuts onto each stud, with one
12mm washer under each nut. Tighten the Jet
nuts to 40 lb-ft

40 lb-ft

40 lb-ft of torque, using a 1/2” socket.