NM Engineering 648846 User Manual
NM Engineering For the car
NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
engineer@nm-
eng.com ∞ www.nm-eng.com
PARTS INCLUDED:
TOOLS REQUIRED:
[1] Power Module
[1] 7mm Nut Driver
[1] 10mm Nut Driver or Wrench
[1] Small Screwdriver
1.
Recommended to install on a cool engine.
2.
Remove the (2) 10mm nuts that hold down front air duct then
push in tab at air filter box to disconnect.
3.
Disconnect rubber support for battery cable from air filter box.
4.
Disconnect electrical connector from MAF (Mass Air Flow)
sensor. First pull outward grey tab then squeeze to release
connector.
5.
Loosen clamp at turbo inlet hose using 7mm Nut Driver and
disconnect.
6.
Remove the 10mm hex bolt located on driver side of air filter
box.
POWER MODULE
– NM.648846
[F56] MINI Cooper S 2.0L 2014-UP
©2015 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.648846 Rev. 01.20.15