NM Engineering 868856 - Manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[email protected] ∞ www.nm-eng.com
PARTS INCLUDED: TOOLS REQUIRED: RECOMMENDED SUPPLIES:
[2] Front brake lines [1] Cap plug [1] 11mm line wrench [1] Vehicle jack ATE Super Blue Brake Fluid (p/n ATE.6302B)
[2] Rear brake lines [1] 14mm line wrench [2] Jack stands Shop towels
Drain pan / bucket
1. Loosen front wheel bolts before lifting vehicle. Raise vehicle
at factory recommended lifting points and secure on jack
stands. NEVER WORK ON A VEHICLE SUPPORTED WITH
ONLY A JACK – ALWAYS USE JACK STANDS. Remove
front wheels.
2. FRONT BRAKE LINES: Undo brake line fitting at chassis
using an 11mm line wrench. Have a cloth and drain pan
available to catch any brake fluid that leaks out. Temporarily
use supplied cap plug over end of hard line to prevent fluid
loss.
3.
Pull off brake line from shock strut.
4. Undo brake line at caliper using a 14mm line wrench.
5. Install NM brake line at caliper and tighten with 11mm line
wrench. Push rubber grommet onto shock strut bracket. With
steering straight, install female brake line fitting into bracket at
chassis and tighten fitting with an 11mm line wrench.
6. REAR BRAKE LINES: From underneath vehicle, undo brake
line fitting at the chassis sub-frame using an 11mm line
wrench. Again, have a cloth and drain pan available to catch
any brake fluid that leaks out. Temporarily install supplied cap
plug to prevent fluid loss.
7.
Pull off brake line at rear shock.
8.
Undo brake line at caliper using 14mm line wrench.
STAINLESS STEEL BRAIDED BRAKE LINE KIT – NM.868856
[R55] MINI Cooper S & non-S Clubman 2008-up
[R56] MINI Cooper S & non-S Hardtop 2007-up
[R57] MINI Cooper S & non-S Convertible 2009-up
WARNING!!! Use extreme caution to ensure that
brake fluid does not come in contact with any
painted surfaces – wash and clean immediately or
permanent paint damage may result.