Neuspeed 62.10.74 User Manual

Page 3

NEUSPEED

• 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX

Visit us on the web…http://www.neuspeed.com

11. Install key in keyway of supplied crankshaft

pulley and gently tap into position.

12. Position pulley on crankshaft and align key to

keyway. Gently press pulley onto shaft. If

pulley does not slide on shaft easily, remove and

check for burs or corrosion. If any burs or

corrosion exists, remove as necessary. Use of

excessive force to install the pulley will

damage both the pulley and the crankshaft

and will void warranty. Install supplied bolt

and torque to 100Nm (74ft-lb.) plus an
additional ¼ turn using VW tool Counter Holder

(T10069) and 27 mm socket.

13. Install power steering pump pulley and torque

pulley bolts to 20Nm (15ft-lb.)

14. Re-install belt in correct running direction and

slowly remove M8 bolt from tensioner, making

sure belt is correctly seated in pulley grooves.

15. Re-install engine cover and under-panel. Install

wheel and lug nuts. Raise vehicle, remove Jack

stand then lower vehicle. Torque lug nuts to

110Nm (81 ft.-lb.) for factory wheels or to wheel

manufactures specifications.

16. Carefully check complete installation to be sure

all fasteners are tight, the belt is correctly

seated in groves of each pulley and that nothing

interferes with the pulleys or belt.

DOC.62.10.74 Rev. 01.18.11