Neuspeed 62.10.33 User Manual
Page 3
NEUSPEED
• 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
15. Install new belt supplied in correct orientation as
illustrated making sure belt is correctly seated in
pulley grooves.
16. Once again using 16mm wrench on tensioner
pulley bolt, turn CCW until tool T10027 or
equivalent can be pulled out, now release
tensioner.
17. Re-install inner fender liner and lower engine
cover.
18. Install wheel and lug nuts. Raise vehicle,
remove Jack Stands then lower vehicle. Torque
lug nuts to recommended factory specifications.
19. Carefully check complete installation to be sure
all fasteners are tight, the belt is correctly
seated in groves of each pulley and that nothing
interferes with the pulleys or belt.
©Copyright 2010, NEUSPEED
®
. All rights reserved. Reproduction in
whole or in part prohibited.
DOC.62.10.33 Rev. 06.18.10
- 95.10.91 (1 page)
- 66.10.91 (1 page)
- 66.10.94 (2 pages)
- 66.10.95 (1 page)
- 15.02.25.3 (2 pages)
- 25.02.19.4 (2 pages)
- 25.02.19.9 (2 pages)
- 25.02.25.3 (2 pages)
- 25.02.25.4 (1 page)
- 25.10.25.8 (2 pages)
- 25.10.27.9 (2 pages)
- 80.10.91 (2 pages)
- 25.02.28.3 (2 pages)
- 45.10.91 (2 pages)
- 15.02.25.4 (2 pages)
- HCB.25.02.25.3 (1 page)
- 32.10.91 (1 page)
- 65.10.72 (1 page)
- 49.10.93 (16 pages)
- 49.10.95 (15 pages)
- 58.45.06.028 (1 page)
- 62.02.65 (2 pages)
- 65.02.65 (2 pages)
- 65.10.79 (2 pages)
- 65.10.60 (2 pages)
- 65.10.92 (2 pages)
- 65.10.61 (3 pages)
- 65.10.76 (4 pages)
- 65.10.99 (3 pages)
- 65.10.80 (2 pages)
- 62.10.32 (3 pages)
- 62.10.71 (4 pages)
- 62.10.74 (3 pages)
- 62.10.99 (1 page)
- 62.10.83 (1 page)
- 65.10.95 (4 pages)
- 65.10.83 (2 pages)
- 65.10.85 (2 pages)
- CHIP.20T.17 (2 pages)
- 65.02.67 (3 pages)
- 62.10.92 (2 pages)
- 62.02.68 (2 pages)
- 62.10.90 (2 pages)
- 65.10.84 (2 pages)