MUTEC iClock User Manual

Page 30

\\\\\\\\\\\\\\\\\\

A N H A N G

> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >

Manual SDs-01 D 3.2.2003 17:45 Uhr Seite 16

GPICNTRL

(setting)

GPIO CONTROL activates the preset selection via the first three GPIO inputs
of the iC-ALARM/GPI interface (encoded binarily).

NAME

(function)

NAME Here you can assign individual names for the presets. One name can
consist of a maximum of eight letters.

PRESET01 – 08

(setting)

These are the factory default names.

NUMBER

NUMBER This informs on the currently active preset number, 01 – 08. This is
a status menu and does not allow any settings by the user.

01 – 08

(setting)

These numbers represent the available preset numbers.

The following is a description of the menu items used for various opera-
tions. Two options are available for storing your current settings:

1) To store a preset without naming it:

Select the SAVE item from the OPERATION menu.

Quit the OPERATION function by pressing the ENTER key, then change to
the NAME function.

Select one of the PRESET01-08 memories using the up/down keys (verti-
cal-arrow keys) and confirm by pressing the ENTER key.

Press the ENTER key twice to position the cursor right in front of the GO
parameter of the PRESET function.

Enable the selected preset by pressing the up-arrow key and the ENTER
key in succession. SHURE? will be displayed. Pressing the ENTER key once
more will load the selected preset and reboot the system. The number of
the selected preset (01-08) will be displayed under NUMBER, and the GO
parameter will appear.

If no user input occurs while SHURE? is displayed, the operation will be
canceled after a short time.

2) To store and name a preset:

Select the SAVE item from the OPERATION menu.

Quit the OPERATION function by pressing the ENTER key, then change to
the NAME function.

Select one of the PRESET01-08 memories using the up/down keys and
confirm by pressing the ENTER key.

Pressing one of the up/down keys followed by the ENTER key will enable
the edit mode. The first character on the left will start flashing. If no
user input occurs, the operation will be canceled after a short time.

Letters, numerals, and special characters can be selected using the up/
down keys. Pressing the ENTER key will proceed to the next character. A
maximum of eight characters can be entered for naming a preset.

When the new preset name is complete, press the ENTER key twice to
switch to the PRESET function. Press any up/down key and the ENTER
key in succession. SHURE? will be displayed. Press the ENTER key again to
store and enable the preset you have just edited. If no user input occurs,
the operation will be canceled after a short time. The preset number will
be displayed under NUMBER.

Switching Presets

The switching over of presets will
cause a short interruption in all

outgoing clock signals!

This manual is related to the following products:

iClock dp