MF Digital SCRIBE SA 3000 - Manual (Page 67)

Scribe SA Standalone Series Operator’s Guide Document Revision: 05/31/06
Page 67
• Press the “Stop No” key if the network does not use DHCP or press
the “START/YES” key if the network does use DHCP. If you press
the ““START/YES” “ key you will be prompted to Restart the
system, if you press the “Stop No” key you will see:
• Enter the 4 sets of numbers of the IP address, one set at a time. After
each octet press the “START/YES” key. Do not enter an IP address
of a machine that is already on the network. When you have entered
in the entire IP address, you will see:
• Enter the 4 sets of numbers of the subnet. Pressing “START/YES”
after each set. You will then see:
• Press the “START/YES” key and then Restart the system by turning
it Off and back On again.