MF Digital SCRIBE SA 3000 - Manual (Page 28)

Scribe SA Standalone Series Operator’s Guide Document Revision: 05/31/06
Page 28
•
To test the alignment of the drive tower, first press the number with
corresponds to the “C” command for calibrate. Then press “I” for input.
This will pick up a CD from the input area and place the CD in the
drive. Inspect the placement of the CD, make adjustments if necessary.
•
After inserting a CD, press “A” for accept, and the arm will pick the CD
out of the drive and place on the output spindle.
• Repeat process as necessary until you are satisfied with the alignment of
the drive bay.
Note: Another command you can use is the “J” command. This
command will retrieve a disc from the input hopper and hover
above an open drive tray. You can then position the drives
while the CD is above the tray. Once aligned, simply push the
“C” for calibrate, the loader will drop the CD and return to
the home position.