LABEC V-18 - Manual (Page 24)

16/18 Manual
21
Fig. 40
Set Deuterium Lamp
Move the cursor on “ D2 Lamp on/off” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 in utility
setting interface, then press 【
ENTER
】 to go into D2 controlling interface.(Fig.
41)
ENTER
RETURN
Fig. 41
Move the cursor on “ OFF” to shut off the D2 lamp by pressing 【∧ ∧ ∧ ∧】 and
【∨ ∨ ∨ ∨】 followed by 【
ENTER
】 . Press 【
RETURN
】 to exit.
Move the cursor on “ On” to lighten the D2 lamp by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】
followed by 【
ENTER
】 . Press 【
RETURN
】 to exit.
Note: The D2 lamp needs about 20 seconds to warm up before being
lightened! (Fig. 42)
ENTER
RETURN
Fig. 42
Shutting off D2 lamp is strongly recommended when you don’t use it
after self-testing.
Set W Lamp
Move the cursor on “ W Lamp on/off” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 in utility
setting interface, then press 【
ENTER
】 to go into W lamp controlling
√ √ √ √Utility
● ● ● ●Lamp Life
○ ○ ○ ○Load Default
○ ○ ○ ○Lamp Change
√ √ √ √Utility
● ● ● ●Date & Time
○
○ ○ ○Dark Current
○
○ ○ ○Reset WL.
√ √ √ √D2 Lamp
● ● ● ●ON √ √ √ √
○ ○ ○ ○OFF
√ √ √ √Utility
● ● ● ● D2 Lamp on/off
○
○ ○ ○ W Lamp on/off
○
○ ○ ○ Printer
√ √ √ √Utility
●
● ● ●Version
D2 Lamp Warming
Please wait …
√ √ √ √D2 Lamp
● ● ● ●ON
○ ○ ○ ○OFF √ √ √ √