LABEC V-18 - Manual (Page 20)

16/18 Manual
17
Press 【 SET
】 in the kinetics pre-testing interface, 5 parameters should be
set before testing.(Fig. 31)
SET
RETURN
Fig. 31
Set Time Interval
Move the cursor on “ Time Interval” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 , followed
by 【
ENTER
】 . ( Fig.32)
ENTER
RETURN
Fig. 32
I nput the new interval time by pressing the numeric keypad followed by
【ENTER】 , it will return the kinetics setting interface.
Note: 1. The range of time interval is 1-200, other value is invalid.
2. If you don’t want to change the value, press【RETURN】directly.
Set Total Time
Move the cursor on “ Total Time” by pressing 【∧ ∧ ∧ ∧】 and 【∨ ∨ ∨ ∨】 , followed by
【
ENTER
】 . ( Fig.33)
ENTER
RETURN
Fig. 33
I nput the new total test time by pressing the numeric keypad followed by
Kinetics
100.0 T%
546.0 nm
√ Kinetics
● ● ● ●Time Interval
○
○ ○ ○Total Time
○
○ ○ ○Test Mode
√ Kinetics
● ● ● ●Time Interval
○
○ ○ ○Total Time
○
○ ○ ○Test Mode
Kinetics
Time Interval = 1 S
Please Input New：
： ： ：
T=
√ Kinetics
● ● ● ●Upper Limit
○
○ ○ ○Lower Limit
○
○ ○ ○Display Data
√ Kinetics
○ ○ ○ ○Time Interval
●
● ● ●Total Time
○
○ ○ ○Test Mode
Kinetics
Total Time= 100 S
Please Input New：
： ： ：
T=