Analyze sample, Basic mode, Select test mode – LABEC V-18 User Manual
Page 11: Begin to test

16/18 Manual
8
Analyze Sample
We provide three test methods in
UV
16/18 series, they are basic mode test, quantitative
and kinetics.
1. Basic Mode
Push the blank cuvette into the light path. In main menu (the last one of Fig. 3), move the
cursor on “Basic mode”, then press
【ENTER】
to go into basic mode test. After
automatically blanking, it will display as the left one of Fig. 4 and wait for the operator.
【RETURN】
to exit.
☺ Select Test Mode
There are three test modes (T%, Abs, Conc. / factor) for you to select by pressing
【SET】
to make choice.
【SET】
【RETURN
RETURN
RETURN
RETURN】
Fig.7
Use
【 】
and
【 】
to move the cursor on
●
●
●
●
Abs. ,
then press
【ENTER】,
If the icon
“
√
√
√
√”
appears at the end of
●
●
●
●
Abs. ,
you have selected successfully. Press
【RETURN
RETURN
RETURN
RETURN】
to exit to the left of Fig.4, blank at the same time. (Fig. 7)
The operation is the same as
Abs
test mode to
select
T%
mode and
Energy
mode.
☺ Begin to Test
Push the sample into light path, press
【 START
START
START
START 】
to go into basic mode test
interface.(Fig. 8)
START
RETURN
Fig. 8
Press
【START
START
START
START】
again, the test result will display on the screen. The operation is the
same if you change your samples.
Note:
√
√
√
√Basic Mode:
●
●
●
●Abs.
√
√
√
√
○
○
○
○T%
○
○
○
○Energy
Basic Mode:
:
:
:
0.000
Abs
546.0 nm
Basic Mode:
:
:
:
0.000
Abs
500.0 nm
500.0nm 0.000Abs
No. WL Abs
1
500.0 0 .000