Keri Systems HPP-100 - Manual (Page 40)

HPP-100 Hand-Held Programmer
Revision 3.3 34
Press . . . [LVL]
TRANSFER CARDS
NEW LEVEL : _
Press . . . [3] [SEND]
There will be a short delay as the card/slot time zone and system configuration attributes
are transferred from the Master Control Unit to all readers on the favorite reader list. As
the transfer is taking place, the LCD will display the following information.
[P] COMMAND [+]
0 2 0 0 > 6 DOOR[S]
(this shows that up to card/slot
200 is being transferred to 6
readers on the favorite reader
list)
Master Control Commands
Master control commands are fundamental commands used for securing and initializing the
Master Control Unit.
Change a PIN [G]
To ensure Master Control Unit programming security, the PIN may be changed at the
user’s discretion.
Example . . . to change the PIN from the factory default value of 1234 to 1156:
Press . . . [9]
CHANGE PIN
OLD PIN _ _ _ _
Press . . . [1] [2] [3] [4]
[VOID] [CLEAR]
OLD PIN * * * *
Press . . . [VOID]
CHANGE PIN