Keri Systems HPP-100 - Manual (Page 29)

HPP-100 Hand-Held Programmer
Revision 3.3 23
Set the Data File Identifier [n/a]
Setting the Data File Identifier allows you to assign a file name to the data being loaded
into the Memory Module.
Example . . . to set a data file identifier of 1 2 3:
Press . . . [0] [7]
ID: x x x
ID: _ _ _
Press . . . [1] [2] [3]
SET SYSTEM ID
ID: 1 2 3
Press . . . [SEND]
Transfer Cards to the Memory Module [N]
Transferring Cards to the Memory Module allows you transfer card data from a Control
Unit to the Memory Module for transfer to another Control Unit or a PC system.
Example . . . to transfer cards to the memory module:
Press . . . [0] [2] [SEND] (allow time for the data to
transfer)
DUMP CARD DATA
[SEND] [CLEAR]