Keri Systems HPP-100 - Manual (Page 31)

HPP-100 Hand-Held Programmer
Revision 3.3 25
Transfer Cards from the Memory Module [G]
Transferring Cards from the Memory Module allows you transfer card data from the
Memory Module to a PXL-100 control unit. You must know the ID number of the data file
you wish to transfer.
Example . . . to transfer cards from data file identifier 1 2 3 in the memory module:
Press . . . [0] [VOID]
LOAD CARD DATA
ID: _ _ _
Press . . . [1] [2] [3]
LOAD CARD DATA
[SEND] [CLEAR]
Press . . . [SEND] (allow time for the data to
transfer)
Level Commands
Level Commands are used for configuring the serial port, manually enrolling a card by code
number, setting security features, and managing the Favorite Reader List.
Serial Port Function
Configure the Serial Port [N]
Configuring the Serial Port establishes communication between the Master Control Unit
and either a serial printer, a PC, or a Modem. To configure the serial port for the serial
printer or the PC, the serial printer or PC cabling at the Master Control Unit’s serial port
must be disconnected. To configure the serial port for the modem, the modem must be
connected and ready to receive initialization string from the Master Control Unit. The
serial printer or PC cabling can be reconnected after the Serial Port is configured.