Keri Systems HPP-100 - Manual (Page 11)

HPP-100 Hand-Held Programmer
Revision 3.3 5
Setting a New PIN
To assign a new PIN, enter the current PIN to enter programming mode as described above.
Press [9] to enter the command to change the PIN. The optional LCD will display:
CHANGE PIN
OLD PIN _ _ _ _
Enter the old PIN value. (If it is the factory default PIN, it will be [0] [0] [0] [0].) The LCD will
display:
[VOID] [CLEAR]
OLD PIN x x x x
Press [VOID]. The LCD will display:
CHANGE PIN
NEW PIN _ _ _ _
Enter your 4 digits to make up the new PIN: [x] [x] [x] [x]. The LCD will display:
[ENROLL] [CLEAR]
NEW PIN x x x x
Press [ENRL]. The LCD will display:
CHANGE PIN
NEW PIN _ _ _ _
Re-enter the new PIN: [x] [x] [x] [x]. The LCD will display:
[SEND] [CLEAR]
NEW PIN x x x x
Press [SEND] to complete the command. The Master Control Unit will now respond to the new
PIN.