Keri Systems PXL-250 Quick Start - Manual (Page 9)

PXL-250 Tiger Controller
1530 Old Oakland Road, Suite 100 01835-002 Rev. 4.2
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 9 of 25
PXL-250
Quick Start Guide
4.5 Connecting a Door Status Input
Each PXL-250 is shipped with an installation kit including all necessary terminal blocks and transorbs. One of these
terminal blocks has a jumper across pins 1 and 2. This terminal block is designated for use on TB-4. If a door switch is
not used on the controller, this jumper prevents a continuous door open status alarm from being received by the
controller. If a door switch is used, simply remove this jumper and install the door switch leads.
Figure 7: Door Status Input Connections
NOTE: A Door Switch must be installed on any door to which anti-passback is being applied for proper tracking of the
anti-passback feature in the Doors program.
4.6 Connecting a Request to Exit (RTE) Input
Figure 8: Request to Exit Input Connections