Clock/timer, View clock, Clock setting – Philips FWI1000 User Manual
Page 30: 1 press clock/timer twice, To exit without storing the setting, Timer setting, Timer setting -31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Clock/Timer
’o"
©
o
o o o
© ® (D
®
©
©
® ® @
O ® O
0'$^©
© ® ©
e®s
"
-
q
-
q
ChO 0-0
0^e 0 0
“o Ö o'o"
IMPORTANT!
When in Eco Power Standby mode, it is not
possible to operate the clock or timer
function.
View Clock
The clock (if it is set) will be shown In Standby
mode.
To view the clock in any source mode
(CD or TUNER, for example)
• Press
CLOCK/TIMER
briefly (or
CLOCK
on
the remote control).
The clock will be displayed for a few seconds.
If the clock has not been set,"" - ■ ■■ will be
displayed.
Clock Setting
The clock can be set In either 12-hour or
24-hour mode (“Rfl Ic?■ uu" or "00■ 00" for
example)
1
Press
CLOCK/TIMER twice.
2
Press
PROG
on the system repeatedly to select
clock mode.
If 12-hour mode Is selected, "Ot1
J“ will
start flashing.
-> If 24-hour mode is selected, "uu-Hu" will start
flashing.
3
Press or ►► on the system repeatedly to set
the hour.
4
Press
M
or
H
on the system repeatedly to set
the minute.
5
Press
CLOCK/TIMER
again to store the
setting.
The clock will start working.
To exit without storing the setting
• Press ■ on the system.
Notes:
- The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
- During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
mode automatically.
Timer Setting
The system can switch on to CQTUNER,
TAPE 2 or INTERNET AUDIO mode
automatically at a preset time, serving as an
alarm to wake you up.
IMPORTANT!
- Before setting the timer, ensure that the
clock is set correctly.
- The timer will always be switched on
after it has been set.
- The timer will not stort if a recording is in
progress.
- The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1
Press and hold CLOCK/TIMER for more than
two seconds to select timer mode,
-> "Ri1 IcF'uu" or"uu-uu" or the last timer
setting will start flashing.
TIMER
will start flashing.
^ The selected source will be lighted while
other available sources are flashing,
2
Press CD, TUNER, TAPE or CONNECT to
select the desired source.
30