Philips FWI1000 - Manual (Page 23)

CD Operation
Disc Playback
To play all discs on the disc tray
Press PLAY ► II
-> All the available discs will play once, then stop.
-» During playback, the selected disc tray, track
number and elapsed playing time of the current
track will appear on the display.
To play one disc only
Press DISC 1, DISC 2 or DISC 3
The selected disc will play once, then stop.
To interrupt playback
Press PAUSE Pll
To resume playback, press PLAY ►!! again.
To stop playback
• Press ■.
To search for a particular passage during
playback
• Press and hold « or ►► and release it when
the desired passage is located.
^ During searching, the volume will be reduced.
To select a desired track
• Press N or H repeatedly (or Digits 0-9 on
the remote control) until the desired track
appears on the display.
• If playback is stopped, press PLAY ►II to start
playback.
Note:
- In Shuffle mode, pressing M will cause the
player to skip only to the beginning of the current
track.
To skip to the beginning of the current
track during playback
• Press M once.
Replace discs during playback
1
Press DISC CHANGE
2
To change the inner disc, press DISC
CHANGE again.
-♦ "DISC CHRfJGE" will be displayed and the
disc will stop playing.
The disc tray will close to retrieve the inner
disc, then reopen with the inner disc accessible.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order
1 Load the desired discs on the disc tray (refer to
"Loading Discs").
2 Press PROG to start programming.
-» PROGRAM will start flashing.
3
Press CD (CD 1 *2*3) or DISC 1/2/3 to select
a disc.
4 Press M or M (or Digits 0-9 on the remote
control) to select the desired track.
5
Press PROG to store the track.
# Repeat steps 3-5 to store other discs and
tracks.
6 Press PLAY ►!! to start program playback.
-» "PERU PRuGRRM" will be displayed.
• To end programming without starting playback,
press ■ once .
-» The total number of tracks programmed and
the total playing time will appear on the display.
Notes:
- If the total playing time is more than "S'S-’5 S'"
or if one of the programmed tracks has a number
greater than 30, then will appear on the
display instead of the total playing time.
- If you attempt to program more than 40 tracks,
"PR lj GRR i I lull " will be displayed.
- If you press any of the DISC 1/2/3 buttons, the
system will play the selected disc or track, and the
stored program will be ignored temporarily.The
PROGRAM symbol also will disappear temporarily
from the display. It will reappear when playback of
the seleaed disc ends.
- During programming, if no button is pressed
within 20 seconds, the system will exit the Program
mode automatically.
To review the program
• Stop playback and press M or ►! repeatedly.
# To exit review mode, press ■ .
23